Fried Spring Onion Pancake - cooking recipe

Ingredients
    3 1/2 cups all-purpose flour
    1 1/4 cups water
    3 green onions, finely chopped
    1/4 - 1/2 cup cooking oil
    salt, to taste
Preparation
    Boil 1 cup of water; Add 1/4 cup of cold water to the boiled water.
    Put 3 cups of flour into a large bowl; Slowly pour approximately 1 cup of the hot water into the flour and stir the bowl while you pour.
    Knead until all of the flour in the bowl has joined the dough; (It may seem like there is too little water at first, but be patient; The dough will be kind of hot when kneading; When you are done, your dough should not be sticky and should look grayish).
    Cover the ball of dough with 2 layers of moist paper towels; Leave covered for at least 1 hour; After an hour or so, the dough should have transformed from gray to white; (You can use the wait-time to prepare the next step).
    Have your chopped onions and cooking oil ready in small bowls; Make sure your rolling pin and rolling board are floured; The steps to follow will need to be repeated until all of the ingredients are used up.
    Make a ball of dough 6-10 ounces in volume; (6 ounces will give you a pancake the size of a CD and will allow you to o fry 2-3 of them at the same time;) Make sure you re-cover the bowl each time you remove some dough.
    Use the roller to flatten the ball into a round circle 2-mm thick; Sprinkle salt (you decide how much) uniformly over the'circle;' Use the roller to roll the salt crystals into the dough.
    Brush a thin amount of cooking oil uniformly over the circle; Then sprinkle 1-2 teaspoons of chopped onion uniformly over the circle; (Read the next step before applying the onions, so as to better understand how much onions to apply).
    Roll the circle into a cylinder; (If you put too much onion, it won't roll well) Gently squeeze as much air out of the'cylinder' as you can; Pinch the ends so the onions wont fall out; (If the sides of your cylinder start popping holes, you made the circle too thin, but don't worry).
    Roll the cylinder along the length and tuck the outer-end into the roll; Your creation should look like a snail shell and be shaped like a rollerskate wheel.
    Rest the'wheel' on its face and use your roller to flatten it into a pancake, around 4-5 mm thick; Don't be worried if onions start spilling out when you flatten.
    Brush your frying pan with cooking oil and fry on low heat; Turn when the bottom is crispy; The final pancake should be crispy on the outside, with a few burn spots on the surface, and dense and chewy on the inside.
    I recommend tasting the first one to decide if you want to add more salt or onion, or if you want to make the pancake thicker or thinner.

Leave a comment