Canadian Bacon Onion Quiche (Oamc) - cooking recipe

Ingredients
    Pastry
    7 tablespoons cold unsalted butter
    1/2 cup 4% large curd cottage cheese
    3/4 cup flour
    1 tablespoon flour
    Filling
    1 1/2 teaspoons unsalted butter
    1/2 cup onion, diced
    1/2 garlic clove, minced
    1 cup cheddar cheese, shredded
    4 ounces Canadian bacon, diced
    6 eggs
    1/4 teaspoon black pepper
    1 dash cayenne pepper
Preparation
    In mixing bowl, use beaters to cream butter, add cottage cheese and beat with mixer, using spoon gradually stir in flour.
    Form into disk, cover with plastic wrap, and chill for at least 1 hour or up to two days. I cut plastic wrap big enough so that I can later roll pastry out on it so clean up is easy.
    Roll out pastry to fit a 9 inch pie plate.
    Transfer pastry to greased pie pan.
    Trim pastry to 1/2 inch beyond edge of plate; flute edges.
    In skillet, saute onions in remaining butter (1 1/2 t.) until golden brown. It is important to get the onions done to your preference because the baking steps do not cook it much more than this step does.
    Remove skillet from heat.
    Stir in garlic and set aside.
    Put cheese at bottom of pastry, top with Canadian bacon.
    in large bowl, add egg and peppers, lightly beat, stir in onion mixture from skillet.
    Pour into pastry shell.
    At this point, either wrap well and freeze or bake at 350 degrees for 40 to 45 minutes or until a knife inserted near the center comes out clean. (After 25 minutes, I peek to see if crust is browned enough and cover just the crust with foil so it is browned just enough. I hate real dark crust. It is not easy to do but worth it IMO.) Let sit for 10 minutes before cutting.
    TO USE FROZEN QUICHE: Remove frozen quiche from freezer 30 minutes before baking. Put rack in middle. Preheat oven to 350 degrees. Place pie on a baking sheet. Bake at 350 degrees for 40 minutes, then cover with foil and move to lowest shelf and bake another 25 minutes or until a knife inserted near the center comes out clean. Let stand for 10 minutes before cutting.

Leave a comment